TurkMesh Communications can install your wireless network, test it and certify its operation. Upon completion, every installation is documented for future reference.

The installation phase is the most physically demanding phase of the project because ladders or lifts may be required to gain access to ceiling areas. Using the survey report as a guide, the installation can proceed smoothly. The access points and antennas will be installed in the facility using the marked up drawing made after the site survey. Usually, the higher the access points and antennas are mounted, the better the signal will propagate.

Some of the activities that will take place during the installation include but are not limited to:

• Mounting of access points
• Installation of NEMA enclosures on case-by-case basis
• Mounting of antennas
• Connection of antennas to access points
• Connection of Backbone LAN to access points
• Connection of power to access points
• Installation and connection of remote power system
• Verification of coverage
• Configuration of access points and hardware to include:
• Proper firmware level
• Radio information (system ID, channel, bit rate)
• IP addresses (provided by customer)
• Verification of backbone connectivity:
• Ping access points
• Ping Hosts

All cabling and power runs should be done and tested prior to the installation of the access points. After completing the installation, testing for proper operation and coverage may indicate the need to move access points and possibly use different settings. Finally, documentation on all the system hardware and software will be provided to the IT staff as an aid to be used when supporting the operational system.